AT&T CL83107 - Page 19

Getting started
13
Battery installation and charging
ì¸ÅÇ»¸´ÁÆʸżÁºÆÌÆǸÀƸÇǼÁºÆ´Å¸·ÂÁ¸ÂÅƾ¼Ãø·Ç»¸»´Á·Æ¸ÇÇ»¸Á
prompts if you want to set call block. Press
MENU/SELECT to start the call block setup via voice guide. To skip the setup,
press
on the handset.
Voice guide to set call block:
If you choose to set call block via voice guide, you hear a voice prompt,
“Smart call blocker is turned on. All your incoming calls are screened when the
directory is empty. You can add contacts in your directory now, so their calls
can be allowed through directly. To add contacts now, press 1. To add contacts
¿´Ç¸ÅßÆÆÂÇÈÅÁÂæ¬À´ÅÇ¶´¿¿µ¿Â¶¾¸ÅßÆÆ”
On the handset:
f Press 1 to add contacts in your directory.
f Press 2 to skip the setup.
f Press 3ÇÂÇÈÅÁÂæ¬À´ÅÇ¶´¿¿µ¿Â¶¾¸Å
To add contacts in your directory:
1. Press
MENU/SELECT to select Add contact.
2. Use the dialing keys to enter a telephone number (up to 30 digits) when
prompted.
f Press qCID or pDIR to move the cursor to the left or right.
f Press MUTE/DELETE to erase a digit.
f Press and hold MUTE/DELETE to erase all digits.
f Press and hold REDIAL/PAUSE to enter a three-second dialing pause (a p
appears).
3. Press
MENU/SELECT to move on to the name.
4. Use the dialing keys to enter a name (up to 15 characters) when prompted.
Each time you press a key, the character on that key appears. Additional
key presses produce other characters on that key. See the chart on page
49.