Answering system
155
Call screening
Use this feature to choose whether incoming messages can be heard over
the speaker when they are being recorded. If you turn call screening on, you
hear the incoming message. While monitoring an incoming message, you can
answer the call by pressing HOME/FLASH on the handset, or HOME on the
telephone base.
To change the setting:
Using a cordless handset:
1. When the handset is in idle mode, press MENU to enter the
main menu.
2. Press
CID or
DIR to scroll to Answering sys, then
press SELECT.
3. Press
CID or
DIR to scroll to Ans sys setup, then
press SELECT.
4. Press SELECT to select Call screening.
5. Press
CID or
DIR to choose On or Off.
6. Press SELECT to save the setting. You hear a
confirmation tone.
Using the telephone base:
1. When the telephone base is in idle mode,
press MENU to enter the main menu.
2. Press SELECT to select Answering sys.
3. Press qCALLER ID or pDIRECTORY to scroll to
Ans sys setup, then press SELECT.
4. Press SELECT to select Call screening.
5. Press qCALLER ID or pDIRECTORY to choose On or Off.
6. Press SELECT to save the setting. You hear a
confirmation tone.
Note: For more information on call screening, see page 155.
Answering system settings
ANS SYS SETUP
Call screening
# of rings
Remote code
BACK SELECT
CALL SCREENING
On
Off
BACK SELECT
SELECT
ANS SYS SETUP
Call screening
# of rings
Remote code
BACK
SELECT
CALL SCREENING
On
Off
BACK
To Next Page
Loading...
Need help?
General
