Bluetooth
27
Bluetooth setup
Auto connection
When an active device moves within Bluetooth range of the telephone base,
or is turned on within range, the telephone base tries to connect to the
device. When the device moves out of range, it is disconnected. Your device
might make a connect or disconnect sound.
A connected device could also be disconnected by:
f Turning o the Bluetooth device.
f Turning o the Bluetooth feature of the device.
f Disconnecting through the telephone base Device list. If you disconnect
through the Device list, the telephone base will not attempt to reconnect
until your device is moved out of range and then moves back in range again.
Bluetooth connection from idle mode
When you have active devices that are not connected, CONNECT appears
on the handset and telephone base in idle mode. Press CONNECT to start
connecting an active device. When there are two active devices, the screen
will prompt you to choose one before connection.
Device list and connection
Up to 4 devices can be paired to the telephone base. All paired devices are
shown on the device list. To use a paired device, it must be in an active slot
(D1: or D2:) on the device list and connected. Both Bluetooth enabled devices
can be used on a cell call at a time.
Once you have paired a device with the telephone base, you do not need to
repeat the pairing procedure again unless you delete the device from the
device list.
Note:
When connecting a Bluetooth device to the device list, all connected devices will be temporarily
disconnected until the procedure completes. It may take up to 2 minutes to reconnect.
To Next Page
Loading...
Need help?
General
