Bluetooth
26
Bluetooth setup
7. When the screen displays the found devices, press
qCALLER ID or pDIRECTORY to highlight your headset, if
necessary, then press SELECT.
f Enter the PIN of your headset, if required. The PIN
for most Bluetooth devices is 0000 (refer to the
user’s manual of your headset), then press NEXT.
8. The screen displays Adding Headset Y when the base
is connecting to your headset (Headset Y represents
the device name of your Bluetooth headset).
9. When a device is successfully connected, the telephone base displays
Headset Y is added and connected to base and the corresponding
status icon 2 (Headset Y represents the device name of your Bluetooth
headset). You hear a conrmation tone. The corresponding light on the
telephone base CELL 2/HEADSET turns on.
If you have trouble pairing your headset, it may not be compatible with
your CLP99287/CLP99387/CLP99457/CLP99487/CLP99547/CLP99557/
CLP99587. Check the Bluetooth compatibility list at
www.telephones.att.com/bluetooth.
Notes:
f The pairing process may take up to one minute. If the pairing process fails, try again.
f When a connected headset is charging, it may disconnect from the telephone base and the CELL 2/HEADSET light
on the telephone base turns off. For some headset models, you may need to turn on the headset and reconnect it to
the telephone base again.
Adding
Headset Y
Headset Y
is added
and connected
to base.
To Next Page
Loading...
Need help?
General
