113
Smart call blocker
Call block settings
Set Smart call blocker on/o
The Smart call blocker feature is set to on by default.
Using a cordless handset:
1. Press MENU on the handset in idle mode to enter the main
menu.
2. Press
CID or
DIR to scroll to Smart call blk, then press
SELECT.
3. Press SELECT again to choose SCB On/O.
4. Press
CID or
DIR to scroll to On or O, and then press
SELECT.
Using the telephone base:
1. Press MENU on the telephone base in idle mode to
enter the main menu.
2. Press qCALLER ID or pDIRECTORY to scroll to Smart call
blk, then press SELECT.
3. Press SELECT again to choose SCB On/O.
4. Press qCALLER ID or pDIRECTORY to scroll to On or O,
and then press SELECT.
Control calls without numbers
Use this setting to control “out of area” or “Private” calls. You can choose to
allow or reject these calls directly. You can also choose to screen them with
or without learning the callers’ names before you decide whether to answer
or reject these calls. Moreover, you can forward these calls to the answering
system.
To change the setting:
Using a cordless handset:
1. Press MENU on the handset in idle mode to enter the main
menu.
2. Press
CID or
DIR to scroll to Smart call blk, then press
SELECT.
SMART CALL BLK
SCB On/Off
Bloc k list
Allow list
S
SELECT
BACK
Play messages
Answering sys
Smart call blk
Directory
BACK
SP
SELECT
BACK
SMART CALL BLK
SCB On/Off
Block list
Allow list
p
q
SELECT
BACK
Answering sys
Smart call blk
Directory
Caller ID log
p
q
SELECT
BACK
Play messages
Answering sys
Smart call blk
Directory
BACK
SP
SELECT
BACK
To Next Page
Loading...
Need help?
General
