Syn248 Installation and Configuration Guide Back to Contents
Installation 22
To install the Deskset on a wall:
1. Plug the Ethernet cable into the port on the back of the Deskset. (See “To connect
the Deskset to the network:” on page 24.)
2. Plug the power adapter into the jack on the back of the Deskset. Skip this step if
using PoE. (See “To connect power:” on page 25.)
3. Place the Deskset base over the mounting plate as shown in . The Deskset will fit
onto wall-mount screws with centers 3 ¼ inches (8.2 cm) or 4 inches (10.2 cm) apart.
Most standard wall plates have screw centers 3 ¼ inches apart.
4. Slide the Deskset base down as shown in .
5. Plug the Ethernet cable into the LAN switch or wall jack.
6. Plug the power adapter into a power outlet not controlled by a wall switch. Skip this
step if using PoE.
7. Make sure the handset tab is in the wall position, as described in “To rotate the
handset tab for wall and Deskset Option 2 installation:” on page 21.
8. Connect the handset to the handset jack on the left side of the Deskset.
Wall-mount screws
with centers 3 ¼ or
4 inches apart
To Next Page
Loading...
