AT&T UNIX - Move Command

Using Office Commands
The screen is cleared and you see the Please login:
prompt. To use the Office again, follow your usual
login procedure.
You can also use the Close command from the Office to
log out. See "Close Command" in this chapter for more
information.
Move Command
The Move command moves folders and files to new
locations in the Office. When an object is moved, it
is deleted from its original location.
You can use either of these methods to enter the Move
command:
o Press <Move>.
o Select IMovel from the Commands menu.
For more information on the various methods of entering
commands, see the "Selecting Objects and Entering
Commands" chapter in this section.
Note
You can cancel the Move command any time
before the Paste step. To cancel a
command, press the Cancl key.
The following procedures show you how to:
o Move files to another folder
o Move a folder
o Move folders and files from the Wastebasket
For information on moving folders and files to and from
the Floppydisk, see "Using Floppy Disks" in this
section.
3-76