AT&T UNIX - Refresh Command; Rename Command

Using Office Commands
Refresh Command
The Refresh command is used primarily for redisplaying
the screen of a remote workstation after a message or
stray characters have disturbed the screen display. If
the Refresh command is executed from the local
workstation, the contents of the current window are
redisplayed.
To execute the Refresh command:
o Press <Rfrsh>, or
o Select I Refresh I from the Commands menu, or
o Press <Esc> <r> <f> in sequence.
The contents of the screen (remote workstation) or
current window (local workstation) are redisplayed.
Rename Command
The Rename command changes the names of existing
folders and files. When you rename a folder or file,
you must give it a new name not already used in the
folder that contains it. You should give each folder
and file a unique name that reflects its contents.
You can use either of these methods to enter the Rename
command:
o Press [RENAME].
o
Select I Rename I from the Commands menu.
For more information on the various methods of entering
commands, see "Selecting Objects and Entering Commands"
in this section.
To rename a folder or file:
3-86
1 Open or resume the object or folder
containing the folder or file you want to
rename.
2 Point to the folder or file you want to
rename.