ATEQ CDF60 - Back Light

Chapter 3 – Start up, adjust and measures
UM-23900B-U User manual ATEQ CDF60 Page 18/40
3.6. BACK LIGHT
The brightness of the backlighting can be set so as to suit the backlighting to the
ambient lighting or your personal preferences.
The screen backlighting is programmable and can be altered.
Backlighting of low brightness will save battery power. Specify a setting that suits the
way you use the instrument.
Enter into the parameters menu, by pressing and
old the ENTER
during 3 seconds.
+/
-
40
.
00
cm
3/
m
i
n
AIR STD.COND.
FLOW : 09.36
TEMP. : 25.8°C
ATM.P : 1010.5 hPa
The PARAMETER menu is displayed. By using the
UP
and DOWN key select
BACK LIGHT parameter.
PARAMETER
PRESS.UNIT.: Pa
>BACK LIGHT: 100 %
A
UTO OFF:
0
5 min
Then press the ENTER key to modify the
parameter (the cursor moves on the right).
PARAMETER
PRESS.UNIT.: Pa
BACK LIGHT: 100 % <
A
U
TO OFF:
0
5 min
By using the UP and DOWN key
modify the backlight value between 0 % (switched
off) and 100 % (maximum).
PARAMETER
PRESS.UNIT.: Pa
BACK LIGHT: 050 % <
A
U
TO OFF:
0
7 min
Validate with the ENTER key.
PARAMETER
PRESS.UNIT.: Pa
>BACK LIGHT: 050 %
A
U
TO OFF:
0
7 min
To return to the measurement mode, press
CANCEL
.
+/
-
40
.
00
cm
3/
m
i
n
AIR STD.COND.
FLOW : 09.36
TEMP. : 25.8°C
ATM.P : 1010.5 hPa