Atlas Copco STbench - Page 12

Introduction EN STbench
12
© Atlas Copco Industrial Technique AB - 9839 0880 01
Software version Change
03.01x
■
Searching a Route updated (for more information, see "STbench with
PC Configuration Manual / STpad Configuration Manual").
■
Editing a tool updated (for more information, see "STbench with PC
Configuration Manual / STpad Configuration Manual").
■
Tool inspections updated (for more information, see "STbench with PC
Configuration Manual / STpad Configuration Manual").
■
Results category updated (for more information, see "STbench with PC
Configuration Manual / STpad Configuration Manual").
■
Summary category for Cm/Cmk and SPC updated (for more information,
see "STbench with PC Configuration Manual / STpad Configuration
Manual").
■
Trace category updated (for more information, see "STbench with PC
Configuration Manual / STpad Configuration Manual").
■
Joints updated (for more information, see "STbench with PC Configura-
tion Manual / STpad Configuration Manual").
■
Joint inspections updated (for more information, see "STbench with PC
Configuration Manual / STpad Configuration Manual").
■
Part updated (for more information, see "STbench with PC Configuration
Manual / STpad Configuration Manual").
■
Part inspections updated (for more information, see "STbench with PC
Configuration Manual / STpad Configuration Manual").
■
Summary category for Cp/Cpk and SPC (joint) added (for more informa-
tion, see "STbench with PC Configuration Manual / STpad Configuration
Manual").
■
Users added (for more information, see "STbench with PC Configuration
Manual / STpad Configuration Manual").
■
General settings added (for more information, see "STbench with PC
Configuration Manual / STpad Configuration Manual").