STbench EN Basic maintenance
© Atlas Copco Industrial Technique AB - 9839 0880 01
47
Basic maintenance
Cleaning the STbench
WARNING Risk of Electric Shock
Never come in contact with electric circuits, there is a risk of serious bodily injury or death.
► Only authorized electricians may carry out work the electrical system.
► Only qualified electricians should perform any electrical troubleshooting or maintenance. Remove
all watches and rings that could contact live electrical circuits.
► Make sure all power to the system has been cut before carrying out any maintenance work.
► Confirm that all safety devices are functioning before operation is resumed.
STbench
■
The STbench is best cleaned with a damp cloth.
■
Use compressed air, a high-pressure cleaner or vacuum cleaner may damage the surface.
■
Use a high-pressure cleaner, the additional risk of water entering the STbench may damage the elec-
tronics or touch screen.
Touch-screen
■
Use neutral detergent or isopropyl alcohol on a clean soft cloth to clean the panel surface.
■
Prevent using any kind of chemical solvent, acidic or alkali solution.
Batteries replacement
We recommend to replace the batteries once every two years.
Contact the local Atlas Copco Customer Center for replacing the batteries.
Oil replacement
We recommend replacing the oil of the hydraulic circuit once every five years.
Contact the local Atlas Copco Customer Center for replacing the oil of the hydraulic circuit.
Backup of the database
It is recommended to create a copy of the database in a separated device with a frequency defined by
Customer IT. Contact the Atlas Copco Customer Center - Service division for the backup.