Atlas Copco STbench - Page 8

Introduction EN STbench
8
© Atlas Copco Industrial Technique AB - 9839 0880 01
Software version Change
04.04x
■
Navigating a forced by piece route added (for more information, see
"STbench with PC Configuration Manual / STpad Configuration Man-
ual").
■
Running a forced by inspection route added (for more information, see
"STbench with PC Configuration Manual / STpad Configuration Man-
ual").
■
Navigating a forced by inspection route added (for more information, see
"STbench with PC Configuration Manual / STpad Configuration Man-
ual").
■
Filtering the routes using the custom fields added (for more information,
see "STbench with PC Configuration Manual / STpad Configuration
Manual").
■
Searching a Route/Tool/Joint/Part/Measuring device/Controller added
(for more information, see "STbench with PC Configuration Manual /
STpad Configuration Manual").
■
Tool inspections parameters updated (for more information, see
"STbench with PC Configuration Manual / STpad Configuration Man-
ual").
■
Tool inspections summary categories updated (for more information,
see "STbench with PC Configuration Manual / STpad Configuration
Manual").
■
Configuration menu updated (for more information, see "STbench with
PC Configuration Manual / STpad Configuration Manual").
■
Common settings updated (for more information, see "STbench with PC
Configuration Manual / STpad Configuration Manual").
■
Measure screen added (for more information, see "STbench with PC
Configuration Manual / STpad Configuration Manual").
■
Reaction bar added (for more information, see "STbench with PC Con-
figuration Manual / STpad Configuration Manual").
■
Exporting STbench logs added (for more information, see "STbench
with PC Configuration Manual / STpad Configuration Manual").
■
Measure angle from (Direct driven strategy) added (for more informa-
tion, see "STbench with PC Configuration Manual / STpad Configuration
Manual").
■
Main panel updated (for more information, see "STbench Operation
Manual").