13
Safety Precautions/Notes on Waterproof and Dustproof Properties
Before cleaning the charging equipment, unplug its power plug from
the outlet or cigarette lighter socket. If the plug remains plugged in
when you clean the equipment, it might cause an electric shock or
short circuit. Also, wipe off dust on the charging equipment's power
plug. If the plug is left covered with dust, it might cause fire.
Install and position in-car devices where they do not hinder driving or
safety equipment such as airbags. Failure to do so might cause a traffic
accident. Install in-car devices following the instructions of their manuals.
The charging equipment is neither waterproof nor dustproof. Do not
use in places subject to direct splashing with water, pet urine or other
liquids. Doing so might result in faults resulting from overheating, fire,
electric shock, or short-circuiting of electronic circuits. In the event that
the product is splashed with liquid, immediately disconnect the power
plug from the power outlet or cigarette lighter socket.
Never handle the charging equipment with wet hands.
If you feel any abnormality with your skin, immediately consult a
dermatologist. Itching, rashes, eczema, etc. sometimes occurs
depending on your physical constitution and condition.
When the charging equipment is not to be used for a long time,
disconnect the power plug from the power outlet or cigarette lighter
socket. Failure to do so might cause electric shock, fire or a fault.
Do not use the desktop holder in a car. Doing so might disturb driving
and cause an accident. It is presumed that the desktop holder will be
used in the room and stable place.
If you feel any abnormality with your skin, immediately consult a
dermatologist. Itching, rashes, eczema, etc. sometimes occurs
depending on your physical constitution and condition.
The materials of parts used on the desktop holder are as follows.
Part Material Surface treatment
Exterior case (Front/rear) ABS resin –
Stand ABS resin –
Silde clips POM resin –
terminal lever POM resin –
Non-slip rubbers POM resin –
Terminals SUS Gold plating
CAUTION
Mishandling might cause
overheating, fire, electric shock,
malfunction, damage, etc.
Be sure to read the following
cautions before use.
Charge the battery in a stable place. If placed on an inclined surface
or wobbly stand, the product might fall causing injury or damage. In
addition, do not cover or wrap the product with a cloth or bedding.
Doing so might cause fire or a fault.
When unplugging the charging equipment's power plug from the outlet
or cigarette lighter socket, hold and pull the power plug. If you pull the
cord, the cord might be damaged.
Do not use the common DC adapter 01/03 (sold separately) with
the car engine stopped. Doing so might result in draining of the car
battery.
Do not use in humid places such as bath areas, or connect/disconnect
the charging equipment with wet hands. Doing so might cause electric
shock or a fault.
Never charge the wet battery pack.
Do not leave the charging equipment connected to the main unit with
the battery pack removed. Doing so might cause fire or electric shock.
micro au IC-Card
WARNING
Be sure to read the following
warnings before use.
Do not put the micro au IC-Card in a cooking apparatus such as a
microwave oven or a pressure vessel. Doing so might cause melting,
overheating, fuming, loss of data or a fault.
To Next Page
Loading...
