80
Appendix/Index
FCC Notice
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
Note:
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on circuit different
from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician
for help and for additional suggestions.
Warning
The user is cautioned that changes or modifications not
expressly approved by the manufacturer could void the
user’s authority to operate the equipment.
FCC RF EXPOSURE INFORMATION
Warning! Read this information before using your phone.
In August 1996, the Federal Communications Commission
(FCC) of the United States, with its action in Report and
Order FCC 96-326, adopted an updated safety standard for
human exposure to radio frequency electromagnetic energy
emitted by FCC regulated transmitters. Those guidelines
are consistent with the safety standard previously set by
both U.S. and international standards bodies. The design
of this phone complies with the FCC guidelines and these
international standards.
Body-worn Operation
This device was tested for typical body-worn operations
with the back of the phone kept 0.59 inches (1.5 cm) from
the body. To comply with FCC RF exposure requirements, a
minimum separation distance of 0.59 inches (1.5 cm) must
be maintained between the user’s body and the back of
the phone, including the antenna. All beltclips, holsters and
similar accessories used by this device must not contain
any metallic components. Body-worn accessories that do
not meet these requirements may not comply with FCC RF
exposure limits and should be avoided.
Turn Off Your Phone Before Flying
You should turn off your phone when boarding any aircraft.
To prevent possible interference with aircraft systems, U.S.
Federal Aviation Administration (FAA) regulations require
you to have permission from a crew member to use your
phone while the plane is on the ground. To prevent any risk
of interference, FCC regulations prohibit using your phone
while the plane is in the air.
To Next Page
Loading...
