15
Safety Precautions/Notes on Waterproof and Dustproof Properties
●
Do not apply excessive force to the product during use. Be sure not to put
the product into a tightly packed bag or place a heavy object on the product
in a bag. Sitting on the product in your pocket might damage the display or
internal circuit board resulting in a malfunction.
Especially, do not put this product in the bag with the main unit open.
Such damage and malfunction are not covered by the warranty, even if there
is no external damage.
●
Do not use the product in extremely hot, cold or humid places. (Use within
an ambient temperature range of 5°C to 35°C and humidity range of 35% to
85%.)
- Charging equipment
- Peripheral devices
●
Do not use the product in extremely hot, cold or humid places. (Use within
an ambient temperature range of 5°C to 35°C and humidity range of 35% to
85%. Temporary use at 36°C to 40°C is allowed.)
- PT003 main unit
- Battery pack, micro au IC-Card (attached to PT003 main unit)
●
Do not use in places subject to lots of dust or vibration.
●
Clean the connection terminals with dry cotton swabs, etc. every now and
then. Soiled terminals might cause poor connection. Do not exert a strong
force to clean the connection terminals to prevent deformation.
●
Clean the product with a soft dry cloth (such as the type used for
eyeglasses). Wiping the product using alcohol, thinner, benzene, detergent,
etc. might erase the printing on the outer casing or cause discoloration.
●
Use as far away as possible from land-line phones, TVs and radios. Use
nearby might affect them.
●
The product may become warm while talking on a call, watching TV(1Seg),
charging or during other operations, depending on the situation, but this is
not abnormal.
●
Turn off the power before removing the battery pack. If you remove the
battery pack with the power on, saved data might be altered or lost.
●
When the product is used by a child, parents or guardians should thoroughly
read the “Instruction Manual” (this manual) and teach the child how to use it.
Main Unit
●
Never use modified au cell phones. Use of a modified device violates the
Radio Law.
This product has acquired the certification of conformity with technical
regulations for the specified radio station based on the Radio Law, and the
"Technical Conformity Mark " is printed on the nameplate of the product as
a certificate.
If the screws of the product are removed and modifications are made to the
internal components, the certification of conformity with technical regulations
will become invalid. Never use the product without the valid certification.
Doing so violates the Radio Law.
●
Do not forcefully press, tap or intentionally subject the display to strong
impact. Doing so might cause scratching or damage.
●
Do not forcefully press your fingernails, sharp objects or hard objects against
keys or display surface. Doing so might cause scratching or damage.
●
This product uses liquid crystal for its main display. The display response
speed may become slow when the ambient temperature is low, which is due
to the property of liquid crystal and not a malfunction. The display response
speed will return to normal at room temperature.
●
Although the main display used on the product is made using high-precision
technology, some pixels (dots) might be lit or out at all times. This is not a
malfunction.
●
When you put the product in your pocket or bag, close the main unit and take
care so that the display does not come in contact with metal objects or other
hard objects, as it might cause scratching or damage. Also, be careful not
to scratch or damage the display by using a strap whose metal or other hard
part comes in contact with the display.
●
Be careful not to pinch your fingers/hand in hinge when opening/closing the
main unit.
●
Do not place stickers on the main display/key side of the cell phone. After
closing the main unit, the keys, etc. may be pressed and cause misoperation,
or key operations while closed may be unavailable or usable time may be
shortened. The PT003 may also be damaged.
●
When wiping the display, wipe with a soft, dry cloth. Use of a moistened
cloth, glass cleaner or other similar liquid might cause a fault.
To Next Page
Loading...
