User can choose origin signal according to real situation, and then connect it with motion control
card. Once origin signal has been set up, the Go Origin direction must be the same as that of Origin,
or Go Origin can’t be finished and even result in damaging to equipment or even hurting people.（“回
原方向必须与原点方向一致”翻译是否准确）
Go Origin speed can’t be too fast or it may go over origin.
b) Laser: User can set up the communication/connection way. SC1000 support
Raycus/IPG/Semiconductor/MaxPhotonics/Super/TXStar/Others.
c) FTC: User can set up the communication/connection way. SC1000 can connect with our
FTC91/FTC61 by Ethernet/IO port/Serial port/MCC3721H. User can connect them by I/O port if you
use other focus tracking controller.
To Next Page
Loading...
