Audio Technica 3000 Series User Manual

48
Setting IP address (IP SETTING)
1
From the menu screen, turn the control dial, select “NETWORK” and then press the control dial.
2
Turn the control dial, select “IP SETTING” and then press the control dial.
3
Select an item you want to set and press the control dial.
Item
Description
IP Mode
Set how to obtain IP addresses.
“Auto”: Set up automatic IP address assignment.
“Static”: Set to use a static IP address.
IP Address
[1]
Specify static IP addresses.
Subnet Mask
[1]
Set the subnet mask.
Gateway
[1]
Set the gateway.
[1] The available setting values change depending on the “RF Mode” setting value.
4
Set each item.
5
Press the BACK button.
The Reboot confirmation screen appears.
6
Turn the control dial to select "Reboot" / "Later" and press the control dial.
When "Reboot" is selected, the transmitter will reboot immediately to complete the setup.
When "Later" is selected, the setup is complete temporarily. Be sure to reboot later. If you do not reboot, the network
settings will not be completed.

Audio Technica 3000 Series Specifications

General

Brand	Audio Technica
Model	3000 Series
Category	Microphone system
Language	English