AudioCodes Mediant E-SBC 2. Installing the Hardware
BroadCloud SIP Trunk 11 AudioCodes Mediant E-SBC
2.2 Mediant 500 E-SBC
Figure 2-7: Front Panel - Ports
Table 2-5: Front Panel
Item # Label Description
1 POWER / STATUS LEDs indicating the status of the power and reboot/initialization.
2 // Reset pinhole button to reset and optionally to restore to factory defaults. To restore to
factory defaults: Press and hold down the pinhole button for at least 12 seconds, but no
longer than 25 seconds, with a paper clip or any other similar pointed object.
3 CONSOLE RJ-45 port for RS-232 serial communication
4 LAN Up to four Gigabit Ethernet (10/100/1000Base-T) ports to connect to LAN (IP phones,
computers, or switches). These ports support half- and full-duplex modes, auto-
negotiation, and straight or crossover cable detection.
6 USB Two USB 2.0 ports. Do not use.
Figure 2-8: Rear Panel – Earth and Power
Table 2-6: Rear Panel
Item # Label Description
1
Protective earthing screw.
2 I / 0 Power switch (O is off; I is on).
3 100-240V~50-60Hz 0.8A Max. Three-prong AC power supply entry.
2.2.1 Cabling
2.2.1.1 Grounding the Device
The device must be connected to earth (grounded) using an equipment-earthing conductor.
To Next Page
Loading...
