AudioCodes Mediant 500L - Step 6: Configure Dial Plan Rules (Optional)

AudioCodes Mediant E-SBC 4. Configuring the Device
BroadCloud SIP Trunk 33 AudioCodes Mediant E-SBC
4.6 Step 6: Configure Dial Plan Rules (Optional)
You can optionally configure rules to manipulate the source and / or destination number.
The manipulation rules use the configured IP Groups to denote the source and destination
of the call. IP Group 0 represents IP-PBX, and IP Group 1 represents BroadCloud SIP
Trunk.
For example, a manipulation can be configured to add a prefix to the destination number
for calls from the IP-PBX IP Group to the BroadCloud SIP Trunk IP Group for specific
destination username prefix.
 To configure a number manipulation rule:
1. Open the IP-to-IP Outbound Manipulation page (Configuration tab > VoIP menu >
SBC > Manipulations SBC > IP-to-IP Outbound).
2. Click Add.
3. Use the following as an example reference for a dial plan rule:
Parameter Value
Index
0
Name Call to desk (arbitrary descriptive name)
Source IP Group IP-PBX (i.e., calls coming from the
IP-PBX)
Destination IP Group BroadCloud (i.e. calls going to the
BroadCloud Service)
Destination Username Prefix
4347 (the number dialed from the IP-PBX
towards the BroadCloud SIP
-Trunk)
Figure 4-14: Configuring IP-to-IP Outbound Manipulation Rule – Rule Tab