BroadCloud SIP Trunk
AudioCodes Mediant E-SBC 16 Document #: LTRT-12552
To connect the device to the BroadCloud service (WAN-DMZ):
1. If the device's IP isn't configured yet, connect as shown in Section 3.
2. If the device's IP has already been configured:
a. Connect one end of a straight-through RJ-45 Cat 5e or Cat 6 cable to the RJ-45
port labeled LAN GE port 1.
b. Connect the other end to the DMZ port assigned by the IT administrator.
Figure 2-15: Connecting the LAN Ports
To connect the device to the IP-PBX (LAN):
1. If the device's IP isn't configured yet, connect as shown in Section 3.
2. If the device's IP has already been configured:
a. Connect one end of a straight-through RJ-45 Cat 5e or Cat 6 cable to the RJ-45
port labeled LAN GE port 3.
b. Connect the other end to your local network LAN layer 2 switch port. This port will
be used to communicate with the local IP-PBX.
2.3.5 Powering up
The device receives power from a standard alternating current (AC) electrical outlet. The
connection is made using the supplied AC power cord.
Table 2-11: Power Specifications
Physical Specification Value
Input Voltage Single universal AC power supply 100 to 240V
AC Input Frequency 50 to 60 Hz
AC Input Current 1.5A
Warning:
• The device must be connected to a socket-outlet providing protective earthing.
• Use only the AC power cord that is supplied with the device.
To Next Page
Loading...
