AudioCodes Mediant 500L - Default Chapter; Table of Contents

Configuration Note Contents
BroadCloud SIP Trunk 3 AudioCodes Mediant E-SBC
Table of Contents
1 Introduction ......................................................................................................... 5
1.1 Making BroadCloud Preparations ............................................................................ 5
1.2 Component Information ............................................................................................ 5
1.2.1 AudioCodes E-SBC Version ...................................................................................... 5
1.2.2 BroadCloud SIP Trunking Version ............................................................................. 5
1.2.3 Solution Topology ...................................................................................................... 6
2 Installing the Hardware ....................................................................................... 7
2.1 Mediant 500L Media Gateway ................................................................................. 7
2.1.1 Front Panel ................................................................................................................ 7
2.1.2 Rear Panel ................................................................................................................. 7
2.1.3 Cabling ....................................................................................................................... 8
2.1.3.1 Connecting Ethernet Interfaces ..................................................................8
2.1.3.2 Connecting to the Power Supply ................................................................9
2.1.4 Powering the Device On / Off .................................................................................. 10
2.2 Mediant 500 E-SBC ............................................................................................... 11
2.2.1 Cabling ..................................................................................................................... 11
2.2.1.1 Grounding the Device ...............................................................................11
2.2.1.2 Connecting Ethernet Interfaces ................................................................12
2.2.1.3 Connecting to the Power Supply ..............................................................13
2.3 Mediant 800B E-SBC ............................................................................................. 14
2.3.1 Front Panel .............................................................................................................. 14
2.3.2 Front Panel LEDs .................................................................................................... 14
2.3.2.1 Operational Status LEDs ..........................................................................14
2.3.3 Rear Panel ............................................................................................................... 15
2.3.4 Cabling ..................................................................................................................... 15
2.3.4.1 Grounding the Device ...............................................................................15
2.3.4.2 Connecting to Ethernet.............................................................................15
2.3.5 Powering up ............................................................................................................. 16
3 Connecting to the Management Interface ....................................................... 19
3.1 Default OAMP IP Address ...................................................................................... 19
3.2 Connecting to the Embedded Web Server ............................................................. 19
3.2.1 Change Default Management User Login Passwords ............................................ 20
4 Configuring the Device ..................................................................................... 21
4.1 Step 1: Download, Install BroadCloud Certified Firmware / Configuration ............. 21
4.2 Step 2: Configure a Network Interface for the Device ............................................ 25
4.2.1 Step 2a: Configure Network Interfaces .................................................................... 26
4.2.2 Step 2b: Configure NAT ........................................................................................... 27
4.3 Step 3: Configure the UDP Ports for RTP between SBC and IP-PBX ................... 29
4.4 Step 4: Configure IP-PBX IP Address .................................................................... 31
4.5
Step 5: Configure SIP Host Name for the IP-PBX ................................................. 32
4.6 Step 6: Configure Dial Plan Rules (Optional) ......................................................... 33
4.7 Step 7: Configure Registration to the BroadCloud Service .................................... 35
4.7.1 Configure Credentials .............................................................................................. 35
4.7.2 Configure the SIP Register Domain Name .............................................................. 36
4.8 Step 8: Check the SIP Trunk Registration Status .................................................. 37
4.9 Step 9: Secure Device Access ............................................................................... 38
4.9.1 Secure Management Access via WAN .................................................................... 38