AudioCodes Mediant 500L - Connecting to the Power Supply

AudioCodes Mediant E-SBC 2. Installing the Hardware
BroadCloud SIP Trunk 9 AudioCodes Mediant E-SBC
2.1.3.2 Connecting to the Power Supply
The device is powered by an external 12V AC/DC power adapter (supplied), connected to
a standard alternating current (AC) electrical wall outlet.
Table 2-3: Power Specifications
Item Description
Power Supply Single universal external AC power supply
Input Ratings 100-240 VAC, 50-60 Hz
Output Ratings 12V/3A
Warning: Use only the AC/DC power adapter supplied with the device.
The device is shipped with the AC/DC power adapter shown the figure below which also
supports interchangeable plugs to suite the electrical wall outlet type requirement of the
country in which the device is being installed.
Figure 2-4: AC/DC Power Adapter
Table 2-4: Power Adapter with Interchangeable Plugs
Item Description
1 Plug slot
2 Plug lock
3 Plug release lever
4 DC power cord
5 DC power plug
 To connect the device to the power supply using the power adapter:
1. Insert the relevant AC plug into the housing power adapter:
a. Insert the top part of the plug into the upper part of the housing slot (1).
b. Press down on the bottom part of the plug until a click is heard, indicating that the
plug is securely inserted in the housing slot. To remove the plug, push and slide
down the OPEN plug release lever (3).