AudioCodes Mediant 500L - Step 3: Configure the UDP Ports for RTP between SBC and IP-PBX

AudioCodes Mediant E-SBC 4. Configuring the Device
BroadCloud SIP Trunk 29 AudioCodes Mediant E-SBC
4.3 Step 3: Configure the UDP Ports for RTP between
SBC and IP-PBX
Note: The default UDP port range is 6000 and up to 8499 (maximum UDP depends on
the maximum capacity of the specific SBC license provided). You may skip this step if
necessary.
 To configure Media Realms:
1. Open the Media Realm Table page (Configuration tab > VoIP menu > VoIP Network
> Media Realm Table).
2. Edit the Media Realm for the LAN ('Voice') interface. For example:
Parameter Value
Index
0
Media Realm Name MRLan (descriptive name)
IPv4 Interface Name
Voice
Port Range Start 6000 (as required by the IP-PBX)
Number of Media Session Legs 250 (media sessions assigned with port range)
Figure 4-10: Configuring Media Realm for LAN