Hardware Installation Manual 26 Document #: LTRT-10236
Mediant 800 MSBR
3.3 Rear Panel Description
The device's rear panel is shown in the figure below and described in the subsequent table.
3.3.1 Median 800B MSBR
Figure 3-3: Mediant 800B MSBR Rear Panel
Note: The figure above is used only as an example.
Table 3-19: Rear Panel Description
Item # Label Description
1 OSN USB Three USB ports (Standard-A type) for connecting computer
peripherals (e.g., mouse and keyboard). These are used when
implementing the OSN.
Note: These ports are available only if the device is equipped
with the OSN server (customer ordered).
2 OSN VGA
15-Pin DB-type female VGA port for connecting to a monitor
(screen). This port is used when implementing the OSN.
Note: This port is available only if the device is equipped with
the OSN server (customer ordered).
3 - Reset button for resetting the OSN server.
4 GE 1
GE 2
GE 3
GE 4
10/100/1000Base-T Ethernet ports (RJ-45) for connecting
directly to the OSN server. For example, one port can be
connected to the LAN (to IP Phones) and the second port to the
WAN interface (to an IP PBX).
Note: The number of ports depends on ordered OSN server
platform (see Section 5.9 on page 61).
To Next Page
Loading...
