Hardware Installation Manual 36 Document #: LTRT-10236
Mediant 800 MSBR
To connect the WAN copper GE port:
1. Connect one end of a straight-through RJ-45 Ethernet cable to the RJ-45 port labeled
GE, located on the front panel.
Figure 5-2: Cabling WAN Copper GE Port – Mediant 800B MSBR
Figure 5-3: Cabling WAN Copper GE Port – Mediant 800C MSBR
2. Connect the other end of the cable to the Ethernet WAN (e.g., ADSL or Cable
modem).
5.2.2 Fiber-Optic Gigabit Ethernet Cabling
The device supports up to two pairs of 1.25 Gbps optical small form-factor pluggable (SFP)
transceiver modules. The SFP module can be used for fiber-optic or copper WAN interface.
Caution Laser
This device contains a Class 1 LED/Laser emitting device, as defined by 21CFR
1040 and IEC825. Do not stare directly into the beam or into fiber optic
terminations as this can damage your eyesight.
To Next Page
Loading...
