Hardware Installation Manual 62 Document #: LTRT-10236
Mediant 800 MSBR
Notes:
• The OSN server platform is a customer ordered feature and thus, the OSN interface
ports, located on the rear panel are available only when the device is purchased with
the OSN server.
• The OSN server also provides an internal interface connection to the device's LAN
switch. In other words, instead of using the Gigabit Ethernet port on the rear panel,
you can use the LAN port #1 located on the front panel for connecting to the OSN
server.
• The table above lists the currently available OSN platforms. This list may change
without notice. To check for any updated information on available OSN platforms,
contact your AudioCodes sales representative.
To connect the OSN server:
1. Perform the following cabling procedures on the OSN server, located on the rear
panel:
a. Connect computer peripherals (e.g., mouse and keyboard) to the USB ports
(Standard-A type) labeled USB.
b. Connect the USB storage device containing the operating system installation files
(Linux or Microsoft Windows) to one of the USB ports, labeled USB.
c. Connect a monitor to the CONSOLE port (USB-C) or VGA female port
(depending on OSN server).
d. Connect to the network using an RJ-45 Ethernet cable connector to the Gigabit
Ethernet port/s (labeled GE).
Figure 5-42: Cabling OSN Server Ports
2. Connect the device to power.
3. Follow the operating system's installation instructions to install the operating system.
To reset the OSN server:
Insert a sharp-pointed object (such as a drawing pin) into the Reset pinhole and then
extract it after a second; the OSN server performs a reset.
To Next Page
Loading...
