AudioCodes Mediant 800 MSBR - Connecting to Power; 5.10.1 Connecting to AC Power; Table 5-9: AC Power Specifications

MSBR Series 63 MSBR Series
Hardware Installation Manual 5. Cabling the Device
5.10 Connecting to Power
The supported power type depends on the Mediant 800 hardware revision:
 Mediant 800B MSBR: Only AC power
 Mediant 800C MSBR: AC and DC redundant power. When both power supplies are
used (AC and DC), the device is powered from the AC power source only. The DC
source starts feeding the device only upon an AC power outage.
Notes: For Mediant 800C MSBR, the device is always shipped with AC power support.
DC power is also available if the device is ordered with DC support (AC/DC power
adaptor is provided).
5.10.1 Connecting to AC Power
The device receives power from a standard alternating current (AC) electrical outlet. The
connection is made using the supplied AC power cord.
Table 5-9: AC Power Specifications
Physical Specification Value
Input Voltage Single universal AC power supply 100 to 240V
AC Input Frequency 50 to 60 Hz
AC Input Current
 Mediant 800B MSBR: 4 A max.

Mediant 800C MSBR:
1.5 A (max.)
Max. Power Consumption

SBC Only (no PSTN):
27W
 Gateway (without OSN): 60W*
* Power consumption varies according to the assembled
hardware configuration.
Warnings:
• The device must be connected to a socket-outlet providing a protective earthing
connection.
• To avoid electric shock or fire, use only the AC power cord that is supplied by
AudioCodes with the device.
• For replacing the power fuse, see Section 6 on page 67.
ご注意
本製品に添付の電源ケーブルは、Mediant 800 MSBR
に専用設計されているため、汎用性がありません.
本電源ケーブルを他の機器に使用されないよう、ご注意ください.