AudioCodes Mediant 800 MSBR - Figure 5-8: Cabling the SHDSL WAN Port; Table 5-2: RJ-11 Connector Pinouts for SHDSL

MSBR Series 39 MSBR Series
Hardware Installation Manual 5. Cabling the Device
Annexes F, G)
 EFM and ATM support
 Wetting current support on the CPE side, according to G991.2
 Supports both Central Office (CO) and CPE (wetting current on CO - excluded)
 TC-PAM 16/32 line code
Cable specification:
 Cable: 26-AWG min. wire
 Connector: RJ-11
 Connector Pinouts:
Table 5-2: RJ-11 Connector Pinouts for SHDSL
Pin
Function
Left RJ-11 Connector Right RJ-11 Connector
2 Pair 1 - Ring Pair 3 - Ring
3 Pair 0 - Ring Pair 2 - Ring
4 Pair 0 - Tip Pair 2 - Tip
5 Pair 1 - Tip Pair 3 - Tip
 To connect the WAN SHDSL port:
1. Connect an RJ-11 SHDSL cable(s) to the device’s SHDSL WAN port(s), labeled
SHDSL.
Figure 5-8: Cabling the SHDSL WAN Port
2. Connect the other end of the cable(s) to an RJ-11 wall jack.