AudioCodes Mediant 800 MSBR - Connecting to WAN; Copper Gigabit Ethernet (GE) Cabling; Table 5-1: RJ-45 Connector Pinouts for Copper GE WAN

MSBR Series 35 MSBR Series
Hardware Installation Manual 5. Cabling the Device
5.2 Connecting to WAN
This section provides a description on how to cable the WAN port. The cabling procedure
depends on the ordered WAN interface.
Note: The device supports multiple WAN redundancies, where multiple WAN interfaces
can serve as backups for the primary or a backup WAN interface. For example, if the
main WAN interface is GE and it fails, the device switches over to the SHDSL WAN
interface. If this WAN interface also fails, the device switches over to the 3G/4G WAN
interface, and so on. For configuring WAN redundancy, refer to the CLI Reference Guide.
5.2.1 Copper Gigabit Ethernet (GE) Cabling
The procedure below describes how to connect the copper Gigabit Ethernet RJ-45 port to
the WAN.
Cable specification:
 Cable: Category 5e or Category 6 shielded twisted pair (STP) straight-through
 Connector: RJ-45
 Connector Pinouts:
Table 5-1: RJ-45 Connector Pinouts for Copper GE WAN
Pin Signal Name
1
Ethernet signal pair
2
3
Ethernet signal pair
6
4
Ethernet signal pair
5
7
Ethernet signal pair
8
Shield Chassis ground