1. PRODUCT DESCRIPTION / PRECAUTIONS
2. PACKAGE CONTENTS
AP8.9 bit is a 9 channel amplifier with 8 channels amplified and settable in bridge mode; it also features a 32 bit,
147 MHz clock speed, 24 bit AD/DA converter digital sound processor (DSP), essential to maximize the acoustic
performance of your car audio system.
It can be interfaced with any factory system, even on cars with built-in audio processors, since with the
de-equalization function, AP8.9 bit will send back a linear signal.
It features 7 signal inputs, 6 Hi-Level and 1 S/PDIF optical digital and provides 8 amplified power outputs and
1 pre-amplified that is optimized for driving a subwoofer.
Each output channel has available: graphically adjustable parametric equalizers, 68-frequency steps electronic
crossover and BUTTERWORTH or LINKWITZ filters with 6-24 dB slopes and a digital time delay line.
The user can make adjustments that allow him or her to interact with AP8.9 bit through the DRC remote control device.
WARNING: 1. a PC provided with Windows XP, Windows Vista, Windows 7 or Windows 8 operating system, 1.5 GHz minimum
processor speed, 1 GB RAM minimum memory and a 1024 x 600 pixels minimum resolution graphics card as
well as at least 512 MB of available hard-disk space are required to install the software and setup the product.
2. Before connecting the product, carefully read this manual. Improper connections may cause damage
to
AP8.9 bit
or to the speakers in your car audio system.
- Multipolar cable, Inputs/Rem:
- Multipolar cable Speakers out:
- 1 - 30A replacement fuse:
- 1.8 m USB cable:
- 2.5 mm hex key:
- 4 4.2 x 50 mm self-tapping, cross head mounting screws:
- AP8.9 bit amplifier
- Warranty
- Quick start guide
- CD ROM containing:
AP8.9 bit Software
This owner’s manual (.pdf)
Audio Test Tracks
To Next Page
Loading...
