10. ACCESSORIES
With the APTK 3 (Audison Prima Tower Kit 3) installation
system, up to 3 AP amplifiers can be stacked in order to
save space without them overheating.
10.4 APTK 3 - AUDISON PRIMA TOWER KIT 3
10.1 ASP - AUTOMATIC SPEAKER PRESENCE
ASP is indispensable when installing AP8.9 bit with some OEM sources
requiring, only at the initial turn-on instant, a resistive load impedance at the
outputs to detect the speakers’ presence.
In case there is no load, the source disables the outputs, usually only for the
Rear section.
Therefore, if during the calibration process you cannot adjust the input signal
level due to lack of signal on some or all of the AP8.9 bit inputs, while installing
the ASP module, when you turn on the AP8.9 bit a temporary load will be
simulated; afterwards that load will automatically get disabled, fixing the issue.
Thanks to ASP, there is no need to mount fixed power resistors at the source
outputs; the resistors would produce heat and, in addition to that, would make
the source heat up unnecessarily.
10.2 ACP 2 - 2 RCA ADAPTER CABLE
It is a kit made up of wiring INPUTS AP8.9 bit with RCA connectors
for the IN1 and IN2 inputs and a 3.5 mm RCA/Jack adapter.
This wiring manages the signals coming from pre-amplified
auxiliary sources (AUX) through the RCA inputs or portable
auxiliary sources using the 3.5 mm RCA/Jack adapter.
10.3 ACP 6 - 6 RCA ADAPTER CABLE
It is a kit made up of wiring INPUTS AP8.9 bit with RCA
terminations for the FL,FR,RL,RR,IN1 and IN2 inputs and a
3.5 mm RCA/Jack adapter.
This wiring manages the signals coming from pre-amplified
auxiliary sources through the RCA inputs or portable
auxiliary sources on the IN1 and IN2 inputs. Portable audio
sources can be connected using the 3.5 mm RCA/Jack
adapter.
10
To Next Page
Loading...
