25
listening area, even if this area is the size of a person’s head. Never measure a position
more than once.
More Measurement Features
• Undo Last – Press this button to erase the previous measurement if the microphone moved
while measuring, noise interrupted the measurement, etc.
• Clear All – Press this button to clear all measurements and start over with the first position.
• Save Measurements – Press this button to save the current measurements to a file. A
dialog will be displayed allowing the user to choose the location of the saved file.
• Load Measurements – Press this button to load a set of measurements from a file. Loading
measurements will clear the current set of measurements. However, after loading
measurements, more positions may be measured.
Load measurement files from the same product that was measured. It is valuable to
make a note of the Zone Configuration settings in use when the measurement file is saved.
Be sure to enter the same Zone Configuration settings that were used when creating the
measurement file that is to be loaded. MultEQ Pro will provide a warning message if these
settings do not match. Continuing with a mismatched zone may result in incorrect
equalization applied to one or more speakers
To Next Page
Loading...
