33
Save Results
Figure 15 - Save Results
• Transfer To [Product] – If applicable, click this button to temporarily transfer filters and
calibration parameters to the product. This is often faster than permanently saving the filters
and will not overwrite previous filters and calibration parameters. Use this feature to test a
new calibration, or new target sound options without overwriting an existing calibration. If the
“Save Permanently to [product]” button is not clicked before exiting the application, the
previous state will be restored.
• Save Permanently to [Product] – Once the target sound options have been finalized,
transfer the filters and calibration parameters (if applicable) to the product’s permanent
memory by clicking this button. This may take several minutes to complete.
• View Results… – Click the “View Results…” button to view a graphical display of the
frequency response correction for each channel. The default HTML browser will
automatically open a window displaying a Customer Certificate titled, “Audyssey MultEQ XT
Room Correction Results.” If the filters have only been temporarily transferred using the
“Transfer to [Product]“ button, the certificate will display a “DRAFT” watermark over the
content. To display the certificate without the “DRAFT” watermark, permanently save the
filters, then click the “View Results…” button again.
To print the certificate, set printing margins to their minimum values. In Internet Explorer,
open the File menu and select Page Setup. Enter “0” for all four margins. The browser will
automatically adjust margins to their minimum values.
By uploading the calibration results to the Audyssey Installer Website, the certificate will be
available for viewing and printing at any time (see Create Customer Certificate, Page 37).
To Next Page
Loading...
