29
and high frequency drivers of many speakers. It is possible to return to this screen later and
disengage this option.
3. Customize the target curve – Press the “Design” button to launch the Target Curve
Designer feature.
4. Proceed to the next screen. Correction filters will be calculated automatically.
In some systems, MultEQ Pro calculates two sets of MultEQ XT filters that are transferred to the
product.
• A set of filters based on the user-selected target curve
• A set of filters based on the Flat curve
In such systems, the Flat target curve will not be displayed as an option. Note that target curve
modifiers (described below in the section Target Curve Designer & Target Curve Editor) are
applied to both the Flat target curve and the user-selected target curve. If enabled, Midrange
compensation is also applied to both the Flat and selected target curves.
Disconnect the Microphone
Warning: Disconnect the Calibrated Preamplifier’s output (LINE OUT) from the product’s
microphone input before continuing. Leaving the microphone connected could cause feedback
at levels that will damage the speakers.
To Next Page
Loading...
