AUMA SA Series Operation Instructions

Read operation instructions first.
●
Observe safety instructions.
●
These operation instructions are part of the product.
●
Retain operation instructions during product life.
●
Pass on instructions to any subsequent user or owner of the product.
Purpose of the document:
This document contains information for installation, commissioning, operation and maintenance staff. It is intended
to support device installation and commissioning.
Reference documents:
●
Manual (Operation and setting ) of actuator controls HART
●
Manual (Fieldbus device integration) of actuator controls HART
Reference documents can be downloaded from the Internet (www.auma.com) or ordered directly from AUMA
(refer to <Addresses>).
Table of contents Page
51. Safety instructions.................................................................................................................
51.1. Basic information on safety
51.2. Range of application
61.3. Applications in Ex zone 22 (option)
61.4. Warnings and notes
71.5. References and symbols
82. Identification...........................................................................................................................
82.1. Name plate
112.2. Short description
123. Transport, storage and packaging........................................................................................
123.1. Transport
143.2. Storage
143.3. Packaging
154. Assembly................................................................................................................................
154.1. Mounting position
154.2. Handwheel fitting
154.3. Multi-turn actuator: mount to valve/gearbox
154.3.1. Output drive type A
164.3.1.1. Stem nut: finish machining
174.3.1.2. Multi-turn actuator (with output drive type A): mount to valve
184.3.2. Output drive types B
194.3.2.1. Multi-turn actuator with output drive types B: mount to valve/gearbox
204.4. Accessories for assembly
204.4.1. Stem protection tube for rising valve stem
214.5. Mounting positions of local controls
214.5.1. Mounting positions: modify
225. Electrical connection.............................................................................................................
225.1. Basic information
245.2. S/SH/SD electrical connection (AUMA plug/socket connector)
265.2.1. Terminal compartment (for mains connection): open
2
SA 07.2 – SA 16.2/SAR 07.2 – SAR 16.2 Control unit: electronic (MWG)
Table of contents AC 01.2 Non-Intrusive HART

AUMA SA Series Specifications

General

Torque range	10 Nm to 32, 000 Nm
Protection class	IP68
Ambient temperature	+70°C
Voltage	24V DC
Communication	PROFIBUS DP, MODBUS RTU, Foundation Fieldbus
Certifications	ATEX, IECEx, CSA, GOST, SIL
Control	Local, Remote, Bus (PROFIBUS, MODBUS)