AUMA SA Series Operation Instructions

6110. Commissioning (settings/options in the actuator).............................................................
6110.1. Switch compartment: open/close
6210.2. Mechanical position indicator (self-adjusting)
6210.2.1. Mechanical position indicator: set
6310.2.2. Gear stage of the reduction gearing: test/set
6410.3. Mechanical position indication via indicator mark (not self-adjusting)
6410.3.1. Mechanical position indicator: set
6410.3.2. Gear stage of the reduction gearing: test/set
6711. Corrective action....................................................................................................................
6711.1. Faults during commissioning
6711.2. Fault indications and warning indications
7111.3. Fuses
7111.3.1. Fuses within the actuator controls
7311.3.2. Motor protection (thermal monitoring)
7412. Servicing and maintenance...................................................................................................
7412.1. Preventive measures for servicing and safe operation
7412.2. Maintenance
7512.3. Disposal and recycling
7613. Technical data.........................................................................................................................
7613.1. Technical data Multi-turn actuators
7813.2. Technical data Actuator controls
8514. Spare parts.............................................................................................................................
8514.1. Multi-turn actuators SA 07.2 – SA 16.2/SAR 07.2 – SAR 16.2
8714.2. AC 01.2 actuator controls
8914.3. Actuator controls AC 01.2 - Fieldbus
9115. Certificates..............................................................................................................................
9115.1. Declaration of Incorporation and EU Declaration of Conformity
94Index........................................................................................................................................
97Addresses...............................................................................................................................
4
SA 07.2 – SA 16.2/SAR 07.2 – SAR 16.2 Control unit: electronic (MWG)
Table of contents AC 01.2 Non-Intrusive HART

AUMA SA Series Specifications

General

Torque range	10 Nm to 32, 000 Nm
Protection class	IP68
Ambient temperature	+70°C
Voltage	24V DC
Communication	PROFIBUS DP, MODBUS RTU, Foundation Fieldbus
Certifications	ATEX, IECEx, CSA, GOST, SIL
Control	Local, Remote, Bus (PROFIBUS, MODBUS)