AUMA SG 05.1 User Manual

245.3.2 Parking frame
255.3.3 Protection cover
255.3.4 Double sealed intermediate frame
266. Operation................................................................................................................................
266.1. Manual operation
266.1.1 Manual operation: engage
266.1.2 Manual operation: disengage
266.2. Motor operation
266.2.1 Local operation
276.2.2 Operation from REMOTE
286.3. Menu navigation via push buttons (for settings and indications)
286.3.1 Short overview: Functions of the push buttons
286.3.2 Structural design and navigation
296.4. Password entry
306.5. Language change in the display
327. Indications..............................................................................................................................
327.1. Status indications in the display
327.1.1 Status indication S0/S6 - operation
337.1.2 Status indication S4 - torque
337.1.3 Torque indication: edit
337.2. Indication lights/LEDs
347.3. Mechanical position indicator/running indication
358. Signals.....................................................................................................................................
358.1. Signals via fieldbus
358.2. Feedback signals via output contacts (binary)
358.3. Feedback signals (analogue)
369. Commissioning (basic settings)...........................................................................................
369.1. Heat-up time for low temperature version
369.2. End stops in part-turn actuator
379.2.1 End stop CLOSED: set
389.2.2 End stop OPEN: set
389.3. Swing angle
399.3.1 Swing angle: modify
409.4. Type of seating: check/edit for end positions
439.5. Torque switching: check/set
479.6. Limit switching: set
509.7. Baud rate, parity and bus addres (slave addess): set
539.8. Further parameters of the Modbus interface
539.9. Test run
539.9.1 Direction of rotation: check
549.9.2 Limit switching: check
549.10. Switch compartment: open
559.11. Mechanical position indicator: set
559.12. Switch compartment: close
569.13. Operating time: set
5810. Corrective action....................................................................................................................
5810.1. Faults during commissioning
5810.2. Fault indications and warning indications
3
SG 05.1 – SG 12.1/SGR 05.1 – SGR 12.1 Control unit: electronic (MWG)
AC 01.1 Non-Intrusive Modbus RTU Table of contents

AUMA SG 05.1 Specifications

General

Brand	AUMA
Model	SG 05.1
Category	Controller
Language	English