Enter XY distance type [X/Y/XY] <XY>: Enter the distance type or press ENTER to
select XY
Polar Stretch
Adds a polar stretch action to the current dynamic block definition. A polar
stretch action can only be associated with a polar parameter. Specifies that
the selection set of objects will stretch or move when the action is triggered
in a dynamic block reference.
Select parameter: Select a parameter in the block definition to associate with the
action
Specify parameter point to associate with action or enter [sTart point/Second
point] <Second>: Specify a parameter point to associate with the action or press
ENTER to associate the action with the second point
Specify first corner of stretch frame or [CPolygon]: Specify the first corner of the
stretch frame or enter cpolygon to create a polygon of any shape as the stretch
frame
Specify opposite corner: Specify the opposite corner of the stretch frame
Specify objects to stretch
Select objects: Select objects to add to or remove from the action’s selection set
Specify objects to rotate only
Select objects: Select objects that will rotate only and not stretch
Specify action location or [Multiplier/Offset]: Specify a location in the block definition
for the action
Multiplier
Changes the associated parameter value by a specified factor when the
action is triggered.
Enter distance multiplier <1.0000>: Enter a value or press ENTER to select 1.0000
Offset
Increases or decreases the angle of the associated parameter, by a specified
number, when the action is triggered.
Enter angle offset <0>: Enter a value or press ENTER to select 0
BASE
Sets the insertion base point for the current drawing
Draw menu: Block ➤ Base
Command line: base (or 'base for transparent use)
Enter base point <current>: Specify a point or press ENTER
Adjust Background Bitmap Placement Dialog Box | 127
To Next Page