The descriptions of the X Scale Factor, Corner, and XYZ options under PX
match the descriptions of the corresponding options under Insertion Point.
PY
Sets the scale factor for the Y axis to control the display of the block as it is
dragged into position.
Specify preview Y scale factor: Enter a nonzero value
Specify insertion point:
Enter X scale factor, specify opposite corner, or [Corner/XYZ] <1>: Enter a value,
enter an option, or press ENTER
The descriptions of the X Scale Factor, Corner, and XYZ options under PY
match the descriptions of the corresponding options under Insertion Point.
PZ
Sets the scale factor for the Z axis to control the display of the block as it is
dragged into position.
Specify preview Z scale factor: Enter a nonzero value
Specify insertion point:
Enter X scale factor, specify opposite corner, or [Corner/XYZ] <1>: Enter a value,
enter an option, or press ENTER
The descriptions of the X Scale Factor, Corner, and XYZ options under PZ
match the descriptions of the corresponding options under Insertion Point.
PRotate
Sets the rotation angle of the block as it is dragged into position.
Specify preview rotation angle:
Specify insertion point:
Enter X scale factor, specify opposite corner, or [Corner/XYZ] <1>: Enter a value,
enter an option, or press ENTER
The descriptions of the X Scale Factor, Corner, and XYZ options under PRotate
match the descriptions of the corresponding options under Insertion Point.
INSERTOBJ
Inserts a linked or embedded object
Insert toolbar:
INSERT Command Line | 553
To Next Page
Loading...