Save As
Saves a PC3 File to a new file name.
Defaults
Restores the settings on the Device and Document Settings tab back to the
default settings.
Configure LPT Port Dialog Box
File menu: Plotter Manager
Command line: plottermanager
Specifies the time that the program waits for the plotter buffer to empty before
sending more data. You specify how much time you want to elapse before
you are prompted to cancel the plot. If your drawings are complex or your
pen speed is very slow, set the timeout value higher than the default (30
seconds). If you begin to receive numerous timeout prompts, your timeout
setting is probably too low.
Timeout
Specifies an amount of time to wait before retrying.
Transmission Retry
Specifies the timeout value in milliseconds.
Settings for COM Port Dialog Box
File menu: Plotter Manager
Command line: plottermanager
Specifies the baud rate, protocol, flow control, and hardware handshaking for
serial ports on plotters that support these settings.
NOTE The settings on your plotter must match the settings in the program or
you cannot plot.
Baud Rate
Specifies the baud rate. Use the fastest available baud rate.
906 | Chapter 17
To Next Page
Loading...