AVANIT SXHD - Page 156

Troubl
eshooting
132 AVANIT SXHD
Symptom
Possible cause(s)
Solution
No audio or video.
No signal or only weak
signal.
Check the cable connections to the
receiver and from the receiver to the
connected devices; fasten cables, if
required.
The TV set does not
show a picture.
The system is not correctly
connected.
Verify connection of cable and
fasten cable, if required.
Picture only in black
and white and/or
incorrect synchroni-
zation.
The video format of your
receiver is not correctly set.
Adapt broadcast television system
of the receiver to the broadcast
television system of the TV set.
The remote control
does not operate.
The batteries are empty.
The remote control shows
into wrong direction.
Replace empty batteries with new
batteries.
Direct the remote control towards
the front panel of the receiver.
Display flashes
Short circuit at antenna in.
Pull off antenna plug from LNB in
and check the same.
Verify that your antenna installation
is properly installed.
New operating software for the receiver will be published, if required. This can
be easily downloaded at the website www.avanit.tv.
If the malfunction still cannot be remedied, then please contact your specialist
dealer.
Service Hotline
In case of technical problems, connection problems or general questions on
settings:
Service Hotline: +49 (0) 7724 94783-54
Fax: +49 (0) 7724 94783-33
E-Mail: info@avanit.tv
Internet: www.avanit.tv