Command mode and
sample prompt
Entrance commands Exit commands
Privileged EXEC 4548GT-
PWR#
enable exit
or
logout
Global Configuration
4548GT-PWR(config)#
From Privileged EXEC
mode, enter
configure
To return to Privileged EXEC
mode, enter
end
or
exit
To exit ACLI completely,
enter
logout
Interface Configuration
4548GT-PWR(config-if)#
From Global Configuration
mode: To configure a port
enter
interface
fastethernet <port
number>
To configure a VLAN enter:
interface vlan
<vlan number>
To return to Global
Configuration mode, enter:
exit
To return to Privileged EXEC
mode, enter:
end
To exit ACLI completely,
enter:
logout
Router Configuration
ERS4000(config-router)#
From Global Configuration
mode, to configure OSPF,
enter:
router ospf
To configure RIP, enter:
router rip
To configure VRRP, enter:
router vrrp
To return to Global
Configuration mode, enter:
exit
To return to Privileged EXEC
mode, enter:
end
To exit ACLI completely,
enter:
logout
ACLI access procedures
About this task
Perform the procedures in this section to access ACLI.
Prerequisites
• Connect to the switch with a console cable, connected directly to the console port, or use
Telnet.
• To connect to the switch remotely, through Telnet, ensure that you enable remote access
and that the switch IP address is valid.
ACLI concepts
Fundamentals December 2011 21
To Next Page
Loading...
