Displaying the Web server status using ACLI
About this task
Use the following procedure to display the Web server status using ACLI.
Prerequisites
• Open an ACLI session
• Access Global Configuration mode
Procedure
To display the Web server status, enter the following command:
show web-server
Variable Definitions
Variable Value
disable Disables HTTP access.
enable Enables HTTP access.
show Shows Web server status.
Starting EDM
To configure and maintain your switch through a Web-based graphical user interface, use the
following procedure to start EDM.
Before you begin
• Ensure that the switch is running.
• Note the switch IP address.
• Ensure that the Web server is enabled.
• Note the user name.
• Note the password.
• Open one of the supported Web browsers.
About this task
Follow these steps to open an EDM session on your switch.
User interface fundamentals
38 Fundamentals December 2011
Comments? infodev@avaya.com
To Next Page
Loading...
