ACLI command modes
ACLI provides four command modes. You must enter the correct mode to perform certain
functions. For more information about ACLI, see
ACLI concepts on page 19.
The following is a list of ACLI command modes:
• User EXEC (exec mode)
• Privileged EXEC (privExec mode)
• Global Configuration (config mode)
• Interface Configuration (config-if mode)
Use the factory default configuration
Perform the commands in the following table to restart the switch using the factory default
configuration.
Command
Purpose
exit Exit the configuration mode.
boot default Return a switch, or switches, to factory
default configuration.
restore factory-default [-y] Return a switch, or switches, to factory
default configuration where [-y] instructs the
switch not to prompt for confirmation.
Configure the management IP address
Perform the commands in the following table to configure and verify the Management IP
Address.
Command
Purpose
ip address <IP> netmask <mask> Set the management IP and mask.
ip default-gateway <default
gateway IP>
Set the default gateway IP address.
ping <default gateway IP> Verify connectivity.
ACLI quick reference
74 Fundamentals December 2011
Comments? infodev@avaya.com
To Next Page
Loading...
