Avaya 4550T-PWR+ - Configure VLANs and Tagged Uplinks

Command Purpose
clock source ntp Set the clock source to NTP.
default clock source Reset clock source to the default, SNTP.
clock sync-rtc-with-ntp enable Synchronize RTC with NTP where
available.
no clock sync-rtc-with-ntp enable Desynchronize RTC with NTP.
default clock sync-rtc-with-ntp enable Set RTC to default – no synchronization with
NTP or SNTP.
ntp [interval] Enable NTP globally and specify the interval
(in minutes) between NTP updates.
default ntp [interval] Set NTP globally to default (disabled) and the
default interval of 15 minutes.
ntp authentication-key <1-2147483647>
<word>
Create authentication keys for MD5
authentication (maximum of 10).
no ntp authentication-key
[ <1-2147483647> ]
Deletes authentication keys for MD5
authentication.
default ntp authentication-key
[ <1-2147483647> ]
Sets authentication keys to the default
value.
ntp server [ <A.B.C.D> | [<IPv6_address>] Adds NTP server entries.
default ntp server [ <A.B.C.D> |
[<IPv6_address>]
Sets NTP server entries to the default
value.
no ntp server [ <A.B.C.D> | <IPv6_address>] Delete an NTP server.
show ntp Display NTP global settings.
show ntp key Display NTP authentication keys.
show ntp server Display NTP server list and settings.
show ntp statistics Display NTP statistics such as NTP server ip
address, stratum, version, sync status,
reachability, root delay, access attempts,
server sync statistics and server fail
statistics.
Configure VLANs and tagged uplinks
Perform the commands in the following table to configure VLANs and tagged uplinks.
ACLI quick reference
76 Fundamentals December 2011
Comments? infodev@avaya.com