Command Purpose
sntp enable Enable SNTP.
show sntp Display SNTP settings SNTP. The SNTP
default setting is Greenwich Mean Time
(GMT).
Configure log settings
Perform the commands in the following table to configure log settings.
Command Purpose
logging volatile overwrite Allow log to roll over when buffer is full.
logging remote address
<A.B.C.D> <WORD>
<A.B.C.D.> is the IP address of the remote
syslog server. <WORD> is the remote host
IPv6 address—maximum 45 characters.
logging remote level
informational
Log all events.
logging remote enable Enable syslogging.
logging remote secondary-
address <A.B.C.D> <WORD>
<A.B.C.D.> is the IP address of the remote
syslog server. <WORD> is the remote host
IPv6 address—maximum 45 characters.
Note:
The configuration of the secondary
address is independent of the
configuration of the first address (logging
remote address command), i.e. you can
configure the secondary address without
configuring the first address.
Configure Secure Socket Layer (SSL)
Perform the commands in the following table to configure SSL.
Command
Purpose
ssl certificate Create a certificate on the next startup. For
switches that include a secure Web server
Avaya recommends that you replace the
ACLI quick reference
82 Fundamentals December 2011
Comments? infodev@avaya.com
To Next Page
Loading...
