Avaya 4550T-PWR+ - Configure Passwords

Command Purpose
no poe-shutdown Enable PoE for AP ports.
shutdown [port] Disable unused ports.
spanning-tree learning fast Set fast spanning tree leaning on access
ports.
name <port name> Name uplink ports. If you need dual uplinks,
Avaya recommends that you add a second
switch, in a stack, and use port 48 of the
second switch as the second uplink.
Exit Terminate port configuration.
interface fastEthernet <uplink
port>
Enter configuration mode at the interface
level to configure port 48 as an uplink port.
speed auto Enable autonegotiate.
spanning-tree learning
<normal or disable>
Depending on the upstream switch location,
set spanning tree to normal or disabled.
name UP-<Switch IP Address>-<Slot>/
<Port>
Example: UP-128.206.95.254-1/2
Exit Terminate uplink configuration.
show interfaces all Display interface settings.
Configure passwords
Perform the commands in the following table to configure ACLI passwords.
Command
Purpose
cli password serial Enable or disable the serial port password.
cli password telnet Enable or disable Telnet and Web
passwords.
no password security Remove password complexity and change
frequency restrictions.
cli password read-only Modify the read-only password (you are
required to enter the password twice).
cli password read-write Modify the read-write password.
cli password stack Modify stack passwords.
cli password switch Modify stand-alone switch passwords.
ACLI quick reference
80 Fundamentals December 2011
Comments? infodev@avaya.com