ACLI commands listed by mode
Use the table in this section to determine the ACLI mode required for a command from the
list.
In column 1, commands are grouped by function, in alphabetical order, and supported modes
that apply to the command group appear in column 2. Where more than one mode is listed for
a group of commands, you can access a command in the group from any of the modes listed
for the group.
Table 4: ACLI commands and modes
ACLI commands ACLI mode
adac Config
asset-id <string> Config
asset-id stack <string>
asset-id unit <1-8> <string>
no asset-id
no asset-id stack
no asset-id unit <1-8>
default asset-id
default asset-id stack
default asset-id unit <1-8>
auto-pvid Config
no auto-pvid
autosave Config
no autosave
default autosave
autotopology Config
banner Config
boot Config, PrivExec
boot default
boot unit <1-8>
brouter port <port> vlan <vid> subnet <ipaddr/mask> [routing
enable]
Config
ACLI quick reference
84 Fundamentals December 2011
Comments? infodev@avaya.com
To Next Page
Loading...
