Avaya 4550T-PWR+ - Configure Simple Network Management Protocol (SNMP); Configure Network Time Protocol (NTP)

Command Purpose
ping [<ipv6address> | <Hostname or
A.B.C.D>] [source <WORD>]
Verify connectivity between a source IPv4
address and another interface.
show ip Verify configuration.
Configure Simple Network Management Protocol (SNMP)
Perform the commands in the following table to configure SNMP.
Command Purpose
snmp-server enable Enable SNMP (the default setting is
disabled).
snmp-server authentication-
trap enable
Enable authentication traps.
snmp-server community ro Set the read-only community name
(requirement: enter community string
twice).
snmp-server community rw Set the read-write community name
(requirement: enter community string
twice).
snmp-server contact "whatever you
want"
Set contact information.
snmp-server location "<Building &
Closet #>”
Set building name and closet information.
snmp-server name "<switch IP
address>"
Maintain coherent Syslog messages.
snmp-server host <host IP>
<community>
Set IP address of Jscan trap receiver.
show sys-info Verify configuration.
show snmp host Verify configuration.
Configure Network Time Protocol (NTP)
Perform the commands in the following table to configure NTP and verify the configuration.
Configure Simple Network Management Protocol (SNMP)
Fundamentals December 2011 75