Avaya 4550T-PWR+ - Page 67

3. Click the Save Configuration tab.
4. Ensure that the AutosavetoNvramEnabled box is not checked.
5. In the Action field, click the copyConfigToNvram button.
6. On the toolbar, click Apply.
7. On the toolbar, click Refresh to check progress.
Config/Image/Diag file tab field descriptions job aid
For more information about fields on the Config/Image/Diag file tab, see the following table.
Field name Description
TftpServerInetAddressType Specifies the IP version of the TFTP server address
TftpServerInetAddress Specifies the TFTP server IP address
BinaryConfigFilename Specifies the name of the binary configuration file
BinaryConfigUnitNumber Specifies the unit number of a switch in a stack
ImageFileName Specifies the software image file name
FWFileName(Diagnostics) Specifies the diagnostics file name
USBTargetUnit Specifies the unit number containing the USB port
Action
• dnldConfigFromUSB—download a configuration
to the switch from a USB device.
• DnldImgIfNewer—download a new software
image to the switch only if it is newer than the current
image.
• dnldFw—download a new diagnostic software
image to the switch.
• dnldConfig—download a configuration file to the
switch.
• upldConfigToUsb—upload a configuration file to a
USB device.
• dnldImgNoReset—download a new software
image to the switch without a switch reset.
• dnldFwNoReset—download a new diagnostic
software image to the switch without a switch
reset.
• upldConfig—upload a configuration file to the
switch from a designated location.
Enterprise Device Manager configuration files
Fundamentals December 2011 67